PRA-AD604
Bosch PRA-AD604 Praesensa 4‑Channel 600W Power Amplifier with integrated spare channel & DSP functions, Operating voltage (VDC): 44 - 60 VDC, 48 kHz Sample rate (kHz), IP‑networked on OMNEO for audio and control, 70/100 V outputs, with a total loudspeaker output power of 600W, Audio‑over‑IP, using OMNEO, the Bosch high‑quality digital audio interface, compatible with Dante & AES67, Steel, RAL9017.
Praesensa Amplifier
Bosch Praesensa PRA-AD604 4‑Channel 600W Power Amplifier
Efficient 4‑channel Power Amplifier
Transformerless, galvanically isolated, 70/100 V outputs, with a total loudspeaker output power of 600 W.
Sound Quality
Audio‑over‑IP, using OMNEO, the Bosch high‑quality digital audio interface, compatible with Dante & AES67; audio sample rate is 48 kHz with 24‑bit sample size
Loudspeaker load
Maximum loudspeaker load 100V mode, 70 V mode all channels: 600 W
Supervision
Controller continuity: Watchdog, Temperature: Overheat, Fan: Rotation speed, Network interface: Link presence
DSP & OMNEO
Digital signal processing per channel
IP‑networked on OMNEO for audio and control
PRA-AD604 Amplifier, 600W 4-channel |
||
Operating voltage (VDC) |
44 - 60 VDC |
|
Power consumption (W) |
230 W maximum |
|
Number of outputs |
4 |
|
Maximum output power (W) |
600 W burst |
|
Number of analog inputs |
1 |
|
Number of Ethernet ports |
2 |
|
Protocols and interfaces |
OMNEO; AES 70 |
|
Sample rate (kHz) |
48 kHz |
|
Signal processing |
Equalization; Limiter; Delay; Level |
|
Rated output voltage (V) |
70;100 V |
|
Frequency response (Hz) |
20 - 20000 Hz |
|
Minimum signal-to-noise ratio (dBA) |
107 dBA |
|
Pilot tone frequency (kHz) |
25,50 kHz |
|
Pilot tone level (V) |
3 V |
|
Protection |
Overheat; Overload; RM S output power limiter; Ground fault; Watchdog; DC output; RSTP; Spare channel; Lifeline |
|
Degree of protection (IEC 60529) |
IP30 |
|
Operating temperature (°C) |
-5 - 50°C |
|
Dimension (H x W x D mm) |
44 x 483 x 400 mm |
|
Weight (kg) |
8,10 kg |
|
Electrical |
||
Loudspeaker load |
||
Maximum loudspeaker load 100 V mode, all channels * 70 V mode, all channels* |
600 W 600 W |
|
Minimum loudspeaker load impedance 100 V mode, all channels* 70 V mode, all channels* |
16.7 ohm 8.3 ohm |
|
Maximum cable capacitance 100 V mode, all channels * 70 V mode, all channels* |
2 uF 2 uF |
|
*All channels combined. |
||
Amplifier outputs |
||
Rated output voltage 100 V mode, 1 kHz, THD <1 %, no load 70 V mode, 1 kHz, THD <1 %, no load |
100 VRMS 70 VRMS |
|
Burst / rated power** All channels combined 100 V mode, load 16.7 ohm 70 V mode, load 8.3 ohm |
600 W / 150 W 600 W / 150 W |
|
Channel 1 100 V mode, load 16.7 ohm // 20 nF 70 V mode, load 11.7 ohm // 20 nF |
600 W / 150 W 420 W / 105 W |
|
Other channels 100 V mode, load 33.3 ohm // 20 nF 70 V mode, load 16.7 ohm // 20 nF |
300 W / 75 W 300 W / 75 W |
|
Full to no load regulation 20 Hz to 20 kHz |
< 0.2 dB |
|
Frequency response Rated power, +0.5 / -3 dB |
20 Hz to 20 kHz |
|
Amplifier outputs |
||
Total Harmonic Distortion + Noise (THD+N) Rated power, 20 Hz to 20 kHz 6 dB below rated power, 20 Hz to 20 kHz |
< 0.5 % < 0.1 % |
|
Intermodulation Distortion (ID) 6 dB below rated power, 19+20 kHz, 1:1 |
< 0.1 % |
|
Signal to Noise Ratio (SNR) 100 V mode, 20 Hz to 20 kHz 70 V mode, 20 Hz to 20 kHz |
> 110 dBA typical > 107 dBA typical |
|
Crosstalk between channels 100 Hz to 20 kHz |
< -84 dBA |
|
DC offset voltage |
< 50 mV |
|
Signal processing per channel Audio equalization Level control Level control resolution Audio delay Audio delay resolution RMS power limiter |
7-section parametric 0 to -60 dB, mute 1 dB 0 to 60 s 1 ms Rated power |
|
Lifeline Sensitivity (100 V out) Mute attenuation Signal to Noise Ratio (SNR) |
0 dBV > 80 dB > 90 dBA |
|
**Full voltage swing into maximum loudspeaker load for speech and music program material (crest factor > 9 dB) |
|
|
Power transfer |
||
Power supply input A/B Input voltage Input voltage tolerance |
48 VDC 44 to 60 VDC |
|
Power consumption (48 V) Sleep mode, no supervision Snooze mode, supervision active Active mode, idle Active mode, low power Active mode, rated power Per active port |
6.0 W 7.5 W 38 W 52 W 222 W 0.4 W |
|
Heat loss (including power supply) Active mode, idle Active mode, low power Active mode, full power |
166 kJ/h (157 BTU/h) 227 kJ/h (215 BTU/h) 339 kJ/h (321 BTU/h) |
|
Supervision |
||
End‑of‑Line detection mode |
Pilot tone 25.5 kHz, 3 VRMS |
|
Power supply input A/B |
Undervoltage |
|
Ground short detection (loudspeaker lines) |
< 50 kohm |
|
Amplifier channel redundancy switching |
Internal spare channel |
|
Amplifier channel load |
Short circuit |
|
Supervision |
||
Loudspeaker line redundancy switching |
A/B group, Class‑A loop |
|
Controller continuity |
Watchdog |
|
Temperature |
Overheat |
|
Fan |
Rotation speed |
|
Network interface |
Link presence |
|
Network interface |
||
Ethernet |
100BASE‑TX, 1000BASE‑T |
|
Protocol |
TCP/IP |
|
Redundancy |
RSTP |
|
Audio/control protocol |
OMNEO |
|
Network audio latency |
10 ms |
|
Audio data encryption |
AES128 |
|
Control data security |
TLS |
|
Ports |
2 |
|
Reliability |
||
MTBF (extrapolated from calculated MTBF of PRA-AD608) |
300.000 h |
|
Environmental |
||
Climatic conditions |
||
Temperature Operating |
-5 to +50 °C (23 to 122 °F) |
|
Storage and transport |
-30 to +70 °C (-22 to 158 °F) |
|
Humidity (non-condensing) |
5 to 95 % |
|
Air pressure (operating) |
560 to 1070 hPa |
|
Altitude (operating) |
-500 to +5000 m (-1640 to 16404 ft) |
|
Vibration (operating) Amplitude Acceleration |
< 0.7 mm < 2 G |
|
Bump (transport) |
< 10 G |
|
Airflow |
||
Fan airflow |
Front to sides/rear |
|
Fan noise Idle condition, 1 m distance Rated power, 1 m distance |
< 30 dBSPLA < 53 dBSPLA |
|
Mechanical |
||
Enclosure |
||
Dimensions (HxWxD) With mounting brackets Rack unit |
44 x 483 x 400 mm (1.75 x 19 x 15.7 in) 19 in, 1U |
|
Ingress protection |
IP30 |
|
Case Material Color |
Steel RAL9017 |
|
Frame Material Color |
Zamak RAL9022HR |