V Series Zone Audio Platform
Clean power for every zone.
V600:2 2-Channel Power Amplifier
600 W across two channels in a compact half-rack chassis.
V Series Zone Audio Platform
Clean power for every zone.
V600:2 2-Channel Power Amplifier
600 W across two channels in a compact half-rack chassis.
V600:2 One Amplifier,Any Speaker Line.
2-Channel Power Amplifier
600 W total power · 2 independent channels · Full 70V / 100V support
V600:2 One Amplifier,Any Speaker Line.
2-Channel Power Amplifier
600 W total power · 2 independent channels · Full 70V / 100V support
Dynacord V600:2 Product Highlights
Explore the key capabilities of the Dynacord V600:2 zone amplifier.
powerTANK
Shares 600 W across channels where needed.
Any Load
Each channel 4 ohm, 8 ohm, 70 V or 100 V.
One-Cable Input
RJ45 input takes four zones from the VZX-8.
Built-In DSP
High-pass, 150 Hz low-pass and limiter.
Energy Saving
Auto Power Down to under 1 W.
Compact
Half rack 1U.
Compact Half-Rack Design
The V600:2 measures just 218 × 44.2 × 269.5 mm (W × H × D) and weighs 2.1 kg. It takes up half the width of a single 19" rack unit, so it fits easily into crowded equipment racks, cabinets and counters.
Flexible Mounting Options
Mount it stand-alone in a 19" rack using the supplied short and long rack ears. You can also mount two V600:2 amplifiers side by side in one rack space with the included connecting plate. The supplied brackets also allow tabletop or under-counter installation.
Ventilation & Placement
Airflow runs side-to-rear. Leave at least 60 mm behind the amplifier and 100 mm above the rack for proper ventilation, and keep it away from direct sunlight and heat sources. It operates reliably from -5°C to +45°C.
Ideal Applications for the Dynacord V600:2
Key specs
- 2 x 300 W rated, 600 W total (powerTANK)
- One channel up to 500 W (4 ohm / 70 V) or 600 W (8 ohm / 100 V)
- Direct drive 70 V / 100 V, no transformer
- Euroblock input + RJ45 (AES72-1E)
- HPF 100 / 150 Hz, LPF 150 Hz, peak limiter
- Remote on / standby, ready / fault relay
- Auto Power Down under 1 W
- Half rack 1U, 44.2 x 218 x 269.5 mm, 2.1 kg
| Specification | Value |
|---|---|
| Product | V600:2-EU Power Amplifier, 600W, 2 Channel |
| Amplifier Class | Class D, fixed frequency |
| Number of Channels | 2 |
| Total Rated Output Power | 600 W |
| Power Technology | powerTANK power sharing between channels |
| Load Handling | Variable Load Drive (4 Ω, 8 Ω, 70 V, 100 V, on either channel simultaneously) |
| Signal Processing | Input routing (dual/parallel), HPF 24 dB/oct (100/150 Hz), LPF 24 dB/oct (150 Hz), flat, peak limiter |
Electrical Specifications
| Specification | 4 Ω | 8 Ω | 70 V | 100 V |
|---|---|---|---|---|
| Rated Output Power (per channel) | 300 W | 300 W | 300 W | 300 W |
| Max Output Power per Channel (power sharing) | 500 W | 600 W | 500 W | 600 W |
| Output Voltage at Rated Power | 34.6 VRMS | 49.0 VRMS | 70.7 VRMS | 100 VRMS |
| Maximum Output Voltage | 40.0 VRMS | 56.0 VRMS | 70.7 VRMS | 100 VRMS |
| Rated Impedance per Channel | 4 Ω | 8 Ω | 16.7 Ω | 33.3 Ω |
| Minimum Impedance per Channel | 2.6 Ω | 4 Ω | 10 Ω | 16.7 Ω |
| Nominal Gain (+6 dBu sensitivity) | 27.0 dB | 30.0 dB | 33.2 dB | 36.2 dB |
| Maximum Gain (0 dBu sensitivity) | 33.0 dB | 36.0 dB | 39.2 dB | 42.2 dB |
| Damping Factor | > 75 | > 150 | > 250 | > 500 |
| Signal-to-Noise Ratio (A-weighted) | > 100 dB | > 102 dB | > 101 dB | > 103 dB |
| Output Noise (A-weighted) | < -68 dBu | < -67 dBu | < -62 dBu | < -61 dBu |
| Crosstalk | < -70 dB | < -75 dB | < -90 dB | < -95 dB |
| Specification | Value |
|---|---|
| THD+N (1/8 rated power, 1 kHz) | < 0.1% |
| Frequency Response (-3 dB), 4 Ω / 8 Ω | HP: 30 / 100 / 150 Hz to 20 kHz; LP: 30 Hz to 150 Hz |
| Frequency Response (-3 dB), 70 V / 100 V | HP: 50 / 100 / 150 Hz to 20 kHz; LP: 50 Hz to 150 Hz |
| Power Requirements | 100 V to 240 V AC, 50 Hz to 60 Hz |
| Power Supply Topology | Switching power supply with power factor correction (PFC) |
| Power Consumption (1/8 rated output) | 115 W |
| Idle Mode (ecoRAIL, no input signal) | < 12 W |
| Standby Mode (Auto Power Down active) | < 1 W |
Connectivity
| Specification | Value |
|---|---|
| Analog Audio Input | 6-pin Euroblock (3.81 mm, male), in parallel with 1× RJ45 (AES72-1E) |
| Maximum Input Level (Level 0 dB) | +18 dBu |
| Input Impedance | 20 kΩ, active balanced |
| Loudspeaker Output | 4-pin Euroblock (5.08 mm, female) |
| Mains Input | IEC C14 |
| Control Port | 1× 5-pin Euroblock (3.81 mm, male) |
| Remote On / Standby | Contact input (overrides front-panel power button) |
| Ready / Fault | Galvanically isolated relay, max 30 VDC / 500 mA DC |
| Front Status LEDs | Signal, limit and fault LEDs per channel; power LED |
Mechanical Specifications
| Specification | Value |
|---|---|
| Form Factor | Half of a 19" rack unit, usable on a tabletop or in a rack |
| Dimensions (H × W × D) | 1.74 in × 8.6 in × 10.6 in / 44.2 mm × 218 mm × 269.5 mm |
| Weight | 4.6 lb / 2.1 kg |
| IEC Protection Class | Class I (grounded) |
| Cooling Concept | dualCOOL: convection cooling on a tabletop or in a rack with spacing between units; forced cooling (side to rear) in a rack without spacing or in extreme thermal conditions |
Environmental Specifications
| Specification | Value |
|---|---|
| Ambient Temperature Limits | -5 °C to +45 °C / +23 °F to +113 °F |
| Operating Altitude | -500 m to 5000 m / -1614 ft to 16404 ft |
Protection Features
| Specification | Value |
|---|---|
| Protection Package | Audio limiters, high temperature, DC, HF, short circuit, back-EMF, peak current limiters, inrush current limiters, mains over/under voltage protection |
| Named Protections | HFL, OCL, RSL, HFP, DCP, OCP, MFP, OBP, OTP, OVP |
Know before you buy
Quick answers about the V600:2, and how it compares.
Where does the V600:2 fit?
Two channels from a shared 600 W in a half-rack box: two zones, or a subwoofer plus satellites (for example EVID-C8.1S-G2 with EVID-C8.2-G2).
How much power does each channel get?
Rated 300 W per channel. With powerTANK one channel can take up to 500 W (4 ohm or 70 V) or 600 W (8 ohm or 100 V) while the other needs less, within 600 W in total.
Does it have built-in signal processing?
Yes: input routing, high-pass at 100 or 150 Hz, a 150 Hz low-pass and a peak limiter.
How is it installed?
1U, half rack wide: two side by side in one rack space, or next to a U Series amplifier; also under a counter or on a table.
V600:2 or V600:4?
| Model | Channels | Rated | One channel max | Size | 6 W speakers at 100 V* |
|---|---|---|---|---|---|
| V600:2 | 2 | 2 x 300 W | 500 W (4 ohm / 70 V), 600 W (8 ohm / 100 V) | Half rack, 1U | About 80 in total |
| V600:4 | 4 | 4 x 150 W | 500 W (4 ohm / 70 V), 600 W (8 ohm / 100 V) | 1U | About 80 in total |
Both share 600 W across their channels (powerTANK) and run each channel at 4 ohm, 8 ohm, 70 V or 100 V. *600 W x 0.8 / 6 W.
How does a V Series system fit together?
The VZX-8 is the brain: 20 sources, 8 zones, DSP, scheduled messages and a browser Web App. Its two RJ45 outputs carry zones 1-4 and 5-8 to V600:4 or V600:2 amplifiers, one cable each. VCS-8 call stations and VWP-EU wall panels daisy-chain on its two accessory ports: bus powered, up to 500 m per port, 16 devices in total, at most 8 call stations.
Who supplies Dynacord in the UAE, and what warranty do I get?
Protechtors General Trading LLC (hik.ae) is an authorized partner of Bosch, Dynacord and Electro-Voice in the UAE, so everything we supply is genuine and comes with a 3-year warranty. Warranty is carry-in: bring the unit to our office in Dubai and after inspection it is repaired or replaced as needed.
We supply Dynacord across the UAE and support you after the sale. Prices are quoted per project: contact us and we will send a quote.